Unraid 6.8.0 and Unraid 6.8.0 rc8

I am unable to turn off/on VM manager.  I do not have any VM installed.

 

I can stop the array and do it but not while the array is online.

 

Could this be a permission issue?  IOMMU?  Working as intended?

 

 

Edited December 20, 20196 yr by Hasodi

Known issue, fixed for next release:

 

As usual, thank you for the update.

So for me its the other way round. I dont know why it isnt enabled anymorfe but i cant start it?!?

 

4 minutes ago, xairam said:

So for me its the other way round. I dont know why it isnt enabled anymorfe but i cant start it?!?

Go to Tools - Diagnostics and attach the complete diagnostics zip file to your NEXT post.

ok

tower-diagnostics-20191222-0121.zip

That diagnostic only has syslog of a few minutes since reboot. I didn't notice anything in the syslog about your issue. Have you actually attempted to enable VM since that syslog began (rebooted)?

 

I do notice a number of warnings from FCP though. Why do you have so many dockers without templates? Did you have a problem with flash at some point? You can't manage a docker in the webUI if it doesn't have a template.

I just started my Homeserver to test some VMs now. I dont use it much. 

 

If you mean the Flash drive not that i know off. 

 

The dead docker services are failed containers didnt bother me to remove them. 

 

 

Try since 30 min to turn the service on, but it doesnt even save changed settings.

9 hours ago, xairam said:

So for me its the other way round.

The issue happens both ways, the problem is with the apply button, stop the array first and it should work.

29 minutes ago, johnnie.black said:

The issue happens both ways, the problem is with the apply button, stop the array first and it should work.

Worked thx.