Show parity check type in history

[Influencer]

At the bottom of the Main tab and in the parity check history, I think it would be helpful to show if it was correcting/non-correcting.

I can be scatterbrained at times and for instance a month ago I had a few parity errors come up after a power outage. So I ran a correcting parity check. All is well.

 

Tonight, a month later, I just happen to glance and see "Last check completed on xx/xx/xx, finding 518 errors." Look at history, two checks ran within a couple days, both finding 518 errors. Took me a minute to remember running the correcting parity check. After running the correcting check I had neglected to run another check to ensure 0 errors.

 

Long story short, would be nice to see if a check was correcting or not so if something like that happens again its easy to know whether a correcting or non-correcting check should be ran.

[itimpi]

If you install the Parity Check Tuning plugin then it adds this information to checks it is controlling/monitoring (as well as the other features it provides).