January 7, 20206 yr I'm trying to add a secondary IP address to unRAID so hypervisors can access it from that IP (and thus move the noise to another VLAN) but I keep trying to set it up and it just won't stick. Whatever I try, when I click on DONE, I'm taken immediately back to the previous page (Settings) and changes are lost. I searched the documentation but the section pertaining to this is beyond vague, I mean… Seriously?! Anyway, thanks !
January 10, 20206 yr Author On 1/7/2020 at 10:29 AM, bonienl said: Make a change and click "Apply" There's no Apply. (It's not available) Edited January 10, 20206 yr by vitaprimo
January 14, 20206 yr Author On 1/10/2020 at 1:42 PM, blaine07 said: Is it looking for a default gateway, too? I tried adding it but it makes no difference. It should not need it though; as long as it does not need to route traffic out of that subnet, there's no need for a gateway and there's already a gateway specified in the existing config anyway.
Archived
This topic is now archived and is closed to further replies.