Phoenix26 Posted February 10, 2020 Share Posted February 10, 2020 Hi, My server is in an odd state and I'm not sure how to resolve, I think it was caused by my 3ware raid controller crashing. Disk 4 Wrong ID. This drive is showing up correctly however I think Unraid is expecting it to be 1TB rather than 4TB, maybe because it was recently upgraded from a 1TB to a 4TB. The old 1TB drive is still installed but unused. Disk 13 Showing up correctly and ID matches but being emulated for some reason? Diagnostics attached. Thanks alphav2-diagnostics-20200210-1839.zip Quote Link to comment
JorgeB Posted February 10, 2020 Share Posted February 10, 2020 This isn't a very straight forward situation, you could re-enable disk4 as 4TB and rebuild disk13, but if disk13 is healthy it would be probably best to do a new config and re-sync parity, can you get a SMART report for disk13? It's not on the diags. Quote Link to comment
Phoenix26 Posted February 10, 2020 Author Share Posted February 10, 2020 (edited) Disk 13 smart attached. Its relatively new so should be healthy. What are the steps to create a new config? Any risks of data loss? alphav2-smart-20200210-1916.zip Edited February 10, 2020 by Phoenix26 Quote Link to comment
JorgeB Posted February 10, 2020 Share Posted February 10, 2020 9 minutes ago, Phoenix26 said: What are the steps to create a new config? -Tools -> New Config -> Retain current configuration: All -> Apply -Then on the main page check all disks are correctly assigned, assign any missing disks if needed, we're going to assume parity is mostly valid, maybe even 100% valid, so check "parity is already valid" before starting the array. After array start if all disks mount correctly run a parity check, if not post new diags. 13 minutes ago, Phoenix26 said: Any risks of data loss? There's always some risk if any of the disks is really failing or have a corrupt file system, but the other options also have similar risks. Quote Link to comment
Phoenix26 Posted February 10, 2020 Author Share Posted February 10, 2020 Have created a new config and the array started correctly, parity check is now running. Will report back once its complete. Thank you very much for your help. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.