February 10, 20206 yr I've had a few unclean shutdowns in the past months, but none since my last parity check. Yet I have 7 corrections this check with an equal number last time. Does anyone have any advice? Just to be clear, I've attached SMART reports to be thorough, but I ran an extended test on all drives recently and everything came up roses. unraid1-diagnostics-20200210-1230.zip unraid1-smart-20200210-1300 (11).zip unraid1-smart-20200210-1300 (12).zip unraid1-smart-20200210-1300 (13).zip unraid1-smart-20200210-1300.zip unraid1-diagnostics-20200210-1230.zip unraid1-smart-20200210-1300 (1).zip unraid1-smart-20200210-1300 (2).zip unraid1-smart-20200210-1300 (3).zip unraid1-smart-20200210-1300 (4).zip unraid1-smart-20200210-1300 (5).zip unraid1-smart-20200210-1300 (6).zip unraid1-smart-20200210-1300 (7).zip unraid1-smart-20200210-1300 (8).zip unraid1-smart-20200210-1300 (9).zip unraid1-smart-20200210-1300 (10).zip
February 10, 20206 yr If it was an equal number both times did you remember to tick the ‘write corrections to parity’ option?
February 10, 20206 yr Author well....I don't know if that is checked...I will look at that when this check ends later today.
February 10, 20206 yr If its not checked then it will always find the same exact errors no matter how many times you run it because you are not correcting them. Edited February 10, 20206 yr by PeteAsking
February 10, 20206 yr Community Expert This last check was correct, so when done do a non correcting one and if all is well it should find 0 errors. P.S. SMART reports are included with the diags, no need to post them also.
Archived
This topic is now archived and is closed to further replies.