April 8, 20206 yr I installed 10gbe network card and it was working, but it was assigned as eth3. I had then unplugged 1gb ethernet from eth0. I had reassigned the VM manager to bridge (br3) which aligned with eth3. I then realized I could reassign the MAC address to eth0 which I thought would solve a couple of issue that I was seeing. When changed the MAC to point to eth0 it asked to reboot, and I did, and now I can't get to unraid other than at the local console. DHCP in my router shows the IP being assigned, but I can't ping it much less anything else. Looking for some assistance on how best to go about fixing this. Thanx!
April 8, 20206 yr Community Expert Delete/rename network.cfg and network-rules.cfg, both on flash/config, then reconfigure.
Archived
This topic is now archived and is closed to further replies.