May 11, 20206 yr Hi, I just set up unraid for the 1st time. I have two 4TB Seagate drives installed (one for parity and a data drive). For some reason, unraid is only recognizing them as 2.2 TB drives. Any suggestions as to what i can do to resolve the issue? Thank you
May 11, 20206 yr Author OK...I'm sure it's a dumb question, but would that be as easy as just updating the BIOS or would I need to install a SAS card as a stop gap before swapping the motherboard?
May 11, 20206 yr Community Expert If the controller has a BIOS update for this issue then update it. I had a controller with this issue and BIOS update fixed it.
May 11, 20206 yr Community Expert Are these ports on the motherboard? It would have to be a pretty old motherboard to have this problem.
May 11, 20206 yr Author Yea, it's an old X58 Supermicro board (supermicro x8st3). The controller is a Broadcom SAS1068E.
May 11, 20206 yr Community Expert 2 minutes ago, DataVamp said: SAS1068E. No update available, you need a new one.
Archived
This topic is now archived and is closed to further replies.