Device is disabled, contents emulated

[MacRaid]

Hey guys, hope you all are doing well and safe. 

So yesterday after installing some extra fans on my UnRaid and NO previous failures/warning, all of a sudden about 20min after starting up I had a message that 33 errors were found on my Disk2, later on I got the "Device is disabled..." message. The disk is a WD Red less than 1 year old and as I said no issues before so I suspect I moved a cable while installing the fans, so I open up again a recheck all cables then after re-start the drive shows "not installed".

This is the first time sending a log from my UnRaid so let me know if the one below is the one I'm supposed to send.

Any help will be appreciated...

generationx-diagnostics-20200626-1523.zip

Edited June 26, 2020 by MacRaid

[JorgeB]

15 minutes ago, MacRaid said:

so I open up again a recheck all cables then after re-start the drive shows "not installed".

Try swapping both cables with another disk, if still not detected it might be dead.

[MacRaid]

Thanks Johnnie, I'll try and do that, at the moment I"m trying to save some family stuff from that disk (which apparently still accesible or maybe I'm just pulling the data from emulated). So I'm putting that data on another disk (inside the unraid) and another external drive then I'll try swapping cables. 

I'll update as soon as posible.

[JorgeB]

1 hour ago, MacRaid said:

maybe I'm just pulling the data from emulated

This.

[MacRaid]

Thanks for confirming that...