Here is my 10 Gigabit Ethernet

 

Dashboard interface shows that only 1000mbps

 

Here are my network settings

I have tried set mtu to 9014, didn't work.

eth0 and eth1 are 10gig ports, eht2 is 1000mbps port

 

I don't know why?

Forgive my poor English~

 

 

 

Hello ,

 

Do you have found a solution ? I have same problem with 2,5G ethernet 

 

Regards,

On 8/10/2022 at 7:40 PM, RHR said:

Hello ,

 

Do you have found a solution ? I have same problem with 2,5G ethernet 

 

Regards,

 

Same issue here. Is it the dependant with system in place? My router can only do 1000mpbs. Although I will upgrade my router eventually anyway, I'm still curious.

On 8/10/2022 at 12:40 PM, RHR said:

Hello ,

 

Do you have found a solution ? I have same problem with 2,5G ethernet 

 

Regards,

What is the speed supported on the device you have connected the NIC into(Switch/Router)

 

@mrjfilippo as above if your router only support 1Gb then the NIC in unraid will only run at 1Gb.

Thanks SimonF , so that was my misunderstanding. The dashboard will just show what eth0 is currently running at and not it's max capacity. 

Edited August 27, 20223 yr by mrjfilippo

 

 

Do you have found a solution ?