wrman Posted June 29, 2020 Share Posted June 29, 2020 Here is my 10 Gigabit Ethernet Dashboard interface shows that only 1000mbps Here are my network settings I have tried set mtu to 9014, didn't work. eth0 and eth1 are 10gig ports, eht2 is 1000mbps port I don't know why? Forgive my poor English~ Quote Link to comment
RHR Posted August 10, 2022 Share Posted August 10, 2022 Hello , Do you have found a solution ? I have same problem with 2,5G ethernet Regards, Quote Link to comment
mrjfilippo Posted August 27, 2022 Share Posted August 27, 2022 On 8/10/2022 at 7:40 PM, RHR said: Hello , Do you have found a solution ? I have same problem with 2,5G ethernet Regards, Same issue here. Is it the dependant with system in place? My router can only do 1000mpbs. Although I will upgrade my router eventually anyway, I'm still curious. Quote Link to comment
SimonF Posted August 27, 2022 Share Posted August 27, 2022 On 8/10/2022 at 12:40 PM, RHR said: Hello , Do you have found a solution ? I have same problem with 2,5G ethernet Regards, What is the speed supported on the device you have connected the NIC into(Switch/Router) @mrjfilippo as above if your router only support 1Gb then the NIC in unraid will only run at 1Gb. Quote Link to comment
mrjfilippo Posted August 27, 2022 Share Posted August 27, 2022 (edited) Thanks SimonF , so that was my misunderstanding. The dashboard will just show what eth0 is currently running at and not it's max capacity. Edited August 27, 2022 by mrjfilippo Quote Link to comment
Jack Paul Posted August 27, 2022 Share Posted August 27, 2022 Do you have found a solution ? Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.