Anyone know what the cause of this is?


Recommended Posts

In syslog ...
 
'
rc.docker: Error response from daemon: Pool overlaps with other one on this address space'

 
Seen it a few times recently.

Check at Settings -> Docker -> upper right switch to advanced view

What Networks are set?

Seems like one is overlapping maybe a Subnet typo or using a Subnet like the standard 172 Network.

Gesendet von meinem Pixel 3a XL mit Tapatalk

Link to comment
I only have Maria and nextcloud dockers installed as preconfigured.

Sent from my CLT-L09 using Tapatalk


Sounds good, and what networks did you configure? Did you run at some point 'docker network create'? As I mentioned before this will setup a network using the 172 as the first octet for the Network Subnet.
Link to comment
They are using 172.17.0.2 & 3 respectively. No command line input at all. In bridge mode.

Sent from my CLT-L09 using Tapatalk


Do they only use 172.17.0.2? Or is it set like:

172.17.0.2:80 192.168.1.2:80

You can have a look in the Docker Tab.

But as I mentioned before please have a look at the advanced docker settings if there are more than one network set within the same Subnet, there is your Problem.
Link to comment

Ok ... i've found them and my br2/br3 look like this

 

IPv4 custom network on interface br2:  Subnet: 192.168.2.0/24 Gateway: DHCP pool: not set
IPv4 custom network on interface br3:  Subnet: 192.168.2.0/24 Gateway: DHCP pool: not set
 
Subnet: 192.168.1.0/24 Gateway: 192.168.1.1 DHCP pool: not set
 
Could this be the cause and nothing to do with the existing dockers?
 
Edited by superloopy1
  • Like 1
Link to comment
Ok ... i've found them and my br2/br3 look like this
 
IPv4 custom network on interface br2:  Subnet: 192.168.2.0/24 Gateway: DHCP pool: not set
IPv4 custom network on interface br3:  Subnet: 192.168.2.0/24 Gateway: DHCP pool: not set
 
Subnet: 192.168.1.0/24 Gateway: 192.168.1.1 DHCP pool: not set
 
Could this be the cause and nothing to do with the existing dockers?
 
Exactly. Just remove one of the Cables, if possible, and try again. Or stop all containers go into the docker settings and remove one of them by deselect them.
Link to comment

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.