I have added an image manually via the command line

docker pull google/cloud-sdk:alpine

Doing this means there is no icon, no options etc.

I guess this isn't an issue as everything works but it would be nice to have it setup like the others.

Do I just need to create a manual file in

/boot/config/plugins/dockerMan/templates-user

if so is the name I need my-container-name.xml or my-image-name.xml ??

Are you doing anything that complex?

I add non-CA dockers via the extended search which pulls results from all of dockerhub, you just need to configure your needed parameters then it works like any other unraid docker.

17 minutes ago, tjb_altf4 said:

Are you doing anything that complex?

I add non-CA dockers via the extended search which pulls results from all of dockerhub, you just need to configure your needed parameters then it works like any other unraid docker.

I don't know enough about Docker to understand how to do what I want but after pulling the image I am creating the container via

docker run -ti --name gcloud-config google/cloud-sdk:alpine gcloud auth login

This creates the container and stores user credentials in it.   

 

I did try via CA but this created the container and I wasn't able to embed my credentails afterwards.   I was using start instead of run but I am not sure the container is configured to be run (docker files for the image are https://github.com/GoogleCloudPlatform/cloud-sdk-docker).

Hey,

 

Go to docker page.

 

Make sure there is the docker hub page in the Repository list:

https://hub.docker.com/

 

Click on add Container give the Container a Name.

 

As repository set "google/cloud-sdk"(without "" and it is case sensitive)

 

Set the variables, path and everything else as described in docker hub and hit apply.

 

https://hub.docker.com/r/google/cloud-sdk/

 

Greetings, stay healthy

 

 

 

 

 

 

On 7/21/2020 at 2:48 PM, D'n'S137 said:

Hey,

 

Go to docker page.

 

Make sure there is the docker hub page in the Repository list:

https://hub.docker.com/

 

Click on add Container give the Container a Name.

 

As repository set "google/cloud-sdk"(without "" and it is case sensitive)

 

Set the variables, path and everything else as described in docker hub and hit apply.

 

https://hub.docker.com/r/google/cloud-sdk/

 

Greetings, stay healthy

The config isn't variables.  It is running a command within the container from the host.

If I create the image this way (the same as going it via the extended search in CA) I cannot run the command.

This is just running

docker run -d --name='cloud-sdk' --net='bridge' -e TZ="Europe/London" -e HOST_OS="Unraid" 'google/cloud-sdk' 

I can't do a docker run as the container has been created and if I try and do a docker start, it just ends instantly.

 

In the end I created the image as above (allowing me to add an image etc.) then I deleted the container

docker -rm gcloud-config

and finally created a new container using the run command.

After that command is run you are able to start the container (although I don't actually need to) and it picks up all the details and images I set when I first added it.  Didn't try adding the xml file manually but it looks like this is the only difference to when I created it via a docker pull