Hi everyone,

It's been a while since I've been on here, hope you're all doing well.

 

Recently I updated my 6.01 system to the latest stable release. 

As instructed I did not included my plugins folder when copying my previous backed up flash drive to the latest release. 

 

The system started and everything seems fine apart from getting Docker to work.

 

When I copy/paste:

 

https://raw.githubusercontent.com/Squidly271/community.applications/master/plugins/community.applications.plg

 

Into Install Plugin - I get the message:

 

plugin: installing: https://raw.githubusercontent.com/Squidly271/community.applications/master/plugins/community.applications.plg
plugin: downloading https://raw.githubusercontent.com/Squidly271/community.applications/master/plugins/community.applications.plg
plugin: downloading: https://raw.githubusercontent.com/Squidly271/community.applications/master/plugins/community.applications.plg ... failed (Network failure)
plugin: wget: https://raw.githubusercontent.com/Squidly271/community.applications/master/plugins/community.applications.plg download failure (Network failure)

 

When I go to my network settings:

 

IPv4 default 192.168.1.1 via eth01

IPv4 172.17.0.0/16docker01

IPv4 192.168.1.0/24eth01

 

I can see Docker seems to be on 172.17.0.0 which I guess should be on my default gateway. 

 

I'm struggling to change this though, when I stop the array and make any changes it does not seem to affect docker, or the option to change that part of Docker is not available. 

 

Any help in getting this fixed would be greatly appreciated.

 

Thanks,

Thomas 

And what's the gateway and dns set to?

The gateway from my network settings is:

192.168.1.1

dns is: 8.8.8.8 and 8.8.4.4 

Thank you

 

Edited August 3, 20205 yr by Thomss

Is there a manual way of installing community apps? -

Perhaps I can just install from the flash? 

 

This one feature is sucking so much of my time and it's so frustrating. 

 

 

Until you get your networking issues resolved it won't help to have CA installed since it won't be able to download anything anyway 

And post your diagnostics, since on the surface everything seems fine...

unraid-diagnostics-20200806-2315.zipThere we go. Thanks for the help guys, I'd love to get to the bottom of this. 

 

Not clear if it would help but your RAM is a bit tight. Can you add any? You are probably going to need more if you intend to run many dockers anyway.

I could add more ram, it ran 6.01 with Sabnzbd and Transmission fine. Does 6.8 require more ram than 6.01? 

Hopefully I can get this download issue sorted and then look at upgrading some stuff. Thank you

I'm unable to delete the 172.16.x.x/16 docker0 route in network settings under 6.9 beta 25. I added a new route that aligns with my network, but get the same result when trying to add

https://raw.githubusercontent.com/Squidly271/community.applications/master/plugins/community.applications.plg

.

I would rename /config/network.cfg to something else (restores default network settings) and try it again.