MatzeHali Posted August 10, 2020 Share Posted August 10, 2020 Hi there, I'm set up with a primary network bond configured with the onboard eth0 and eth1 being bond1 and a secondary bond2 with an additional 10gbe-card eth2ð3. How do I configure a VM to bridge to the second bond. With the normal br0 it bridges to bond1 and I can't get it off of this. If I put in br1 in the XML it throws an error that this is not available. Same with bond2. Thanks, M Quote Link to comment
MatzeHali Posted August 11, 2020 Author Share Posted August 11, 2020 Solved this by setting up bridging for the second bond, too. That slipped my attention before. With that bridging enabled, I was able to set br1 within the VM settings. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.