I'm currently trying to deal with the fact my server died mid-rebuild and completely borked Disk1 (now showing "Unmountable File System Present") and the Web UI is currently driving me to frustration.

 

80% of the time, I'm getting "Hmmm… can't reach this page. It looks like 192.168.XX.XX closed the connection" and then 20% of the time it works fine for a few minutes before crashing and burning again.

 

I've tried 3 different laptops, a tablet, 2 phones and a PC and the behaviour is consistent. Also, my 2nd UnRaid server is behaving exactly as expected.

 

I've attached the diagnostics, in case anyone has any suggestions?!

tower-diagnostics-20200828-0806.zip

I have exactly the same problem today, Had a problem with my Modem, had to do a factory reset, Now every 2 mins or so, can not access.

My other 2x Towers are fine, just my Tower3 which is all my movies.

 

Diags attached

tower3-diagnostics-20200830-1518.zip

Did you reset the modem while the server was still on?  (at 15:13?)  The network went down at that time.  If this wasn't when you reset modem, then I'd try a different port on the switch / modem

No, I reset the modem yesterday, today just can not stay connected.
Changed cables and network switch also.
Moved Tower to another room and same problem.

 

Thanks for looking and suggestions

 

This Tower3 has been online for a very long time with no issues, strange my other 2x Towers were not effected, running the same UnRaid version

Changed port on my Modem, still the same. 😡
Replaced my 16 port switch with a new unit, still the same. Hmmmmmmm

Think I will shutdown all my network switches (I have about 10x switches) and repower them and see what happens

I reset my whole network, still the same

 

After messing around for the last couple of hrs, I changed my IP address to automatic, then back to a static IP address after a reboot, and now all is good.

Weird, never had that happen before.

How do we do this via the CLI? I can access my UI every 15th time and even then it fails the next page I load or settings that is changed. Also I tried a putty connection and it connected prefect but failed 10 seconds later. I am running 6.8.3 and when I get home was planning on trying older version / different usb. No idea what the issue is.

5 minutes ago, drowsyfish said:

How do we do this via the CLI? I can access my UI every 15th time and even then it fails the next page I load or settings that is changed. Also I tried a putty connection and it connected prefect but failed 10 seconds later. I am running 6.8.3 and when I get home was planning on trying older version / different usb. No idea what the issue is.

Possibly issue with flash disconnecting. Be sure to boot from a USB2 port.

 

Go to Tools - Diagnostics and attach the complete Diagnostics ZIP file to your NEXT post.

On 9/1/2020 at 8:23 AM, trurl said:

Possibly issue with flash disconnecting. Be sure to boot from a USB2 port.

 

Go to Tools - Diagnostics and attach the complete Diagnostics ZIP file to your NEXT post.

I was using a 2.0 port but I had remembered my boss saying he has had alot of issues with certain 3.0 flash drives for booting. Swapped for another and all was well.