September 16, 20205 yr I recently replaced my current mobo+cpu (i7 6700k) to a Ryzen 3600. It seemed to boot fine (login prompt displayed on monitor) but I was unable to connect to the webserver (entered IP in browser) After a series of reboots with no luck. I read that there might be an issue with the flash drive (which i could still read and use on my win10 comp). So i made a new flash drive and copied /config from my old flash drive over to it. Once booted i was able to connect to the webserver and I re-registered my key to the new flash drive. The assigned drives seemed ok so I started the array. There seemed be some conflict or error because my parity and cache drives immediately appeared in my un assigned drives list. I tried stopping the array but it wouldnt umount. When I rebooted the server the webserver would not respond. Logging in directly showed a empty /boot directory. I gathered this has coruppted the drives so the webserver wont start. So I did the whole processes of creating a new flash drive again and the problems repeats the moment i start the array. Im at a loss of what to do. Would a new config help?
Archived
This topic is now archived and is closed to further replies.