treecats Posted October 1, 2020 Share Posted October 1, 2020 I have the same issue with UDMA CRC error count. How do you force a recheck? I did a shut down and replacement of the SATA cable. Now it's doing Parity-"Sync/Data-Rebuild in progress", will this re-check UDMA CRC error? I rather not wait another 8 hours for this to finish. Thanks! Quote Link to comment
trurl Posted October 1, 2020 Share Posted October 1, 2020 I have split your post into its own thread. Go to Tools - Diagnostics and attach the complete Diagnostics ZIP file to your NEXT post. Quote Link to comment
treecats Posted October 1, 2020 Author Share Posted October 1, 2020 (edited) Ok, thanks! uploading the diag file. I am just wondering if "Sync/Data-Rebuild in progress" will force a re-check of "UDMA CRC error" on the drive. If not, what is the procedure to do that? Thanks! zerg-diagnostics-20201001-1718.zip Edited October 1, 2020 by treecats Quote Link to comment
itimpi Posted October 1, 2020 Share Posted October 1, 2020 UdMA CR`c errors were connection issues that would have caused retries at the time until the transfer either completed OK or a failure was reported. As such there is nothing to re-check. Also the count never gets reset - it can only increase, so as long as it remains stable you are no longer getting such errors. Quote Link to comment
treecats Posted October 2, 2020 Author Share Posted October 2, 2020 Ok. This is the information I am looking for, even though there isn't much I can do. Thank you very much! Please close thread! Quote Link to comment
trurl Posted October 2, 2020 Share Posted October 2, 2020 You can acknowledge the SMART warning by clicking on it on the Dashboard page. It will warn again if the count increases. 6 hours ago, treecats said: Now it's doing Parity-"Sync/Data-Rebuild in progress", will this re-check UDMA CRC error? I rather not wait another 8 hours for this to finish. You must let it finish. Quote Link to comment
treecats Posted October 2, 2020 Author Share Posted October 2, 2020 Yes, I understand that. waiting "Parity-Sync/Data-Rebuild" to finish! Thanks! Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.