ok so 

the usb drive that i boot unraid off of somehow got corrupted 

i am trying to re setup my disks in a fresh install of unraid but if for obvious reasons was unable to get a screenshot of the disk order because it would no longer boot

 

so i am trying to find out if i cant get my disk order from the diagnostics data i have form a while back

 

if this the wrong way to go about getting the array back up and running on anuther install please do tell me 

any help would be very much appreciated  

tower-diagnostics-20200620-0930.zip

You can get it from the diagnostics, but make it's still the same confirguration:

 

Jun 14 17:45:51 Tower kernel: md: import disk0: (sdc) WDC_WD40EZRZ-75GXCB0_WD-WCC7K1HAZY9C size: 3907018532
Jun 14 17:45:51 Tower kernel: md: import disk1: (sdd) WDC_WD40EZRZ-00GXCB0_WD-WCC7K0HN8TLJ size: 3907018532
Jun 14 17:45:51 Tower kernel: md: import disk2: (sdb) WDC_WD40EZRZ-00GXCB0_WD-WCC7K2CVN674 size: 3907018532

 

Disk0 was parity.

5 minutes ago, JorgeB said:

You can get it from the diagnostics, but make it's still the same confirguration:

 

Jun 14 17:45:51 Tower kernel: md: import disk0: (sdc) WDC_WD40EZRZ-75GXCB0_WD-WCC7K1HAZY9C size: 3907018532
Jun 14 17:45:51 Tower kernel: md: import disk1: (sdd) WDC_WD40EZRZ-00GXCB0_WD-WCC7K0HN8TLJ size: 3907018532
Jun 14 17:45:51 Tower kernel: md: import disk2: (sdb) WDC_WD40EZRZ-00GXCB0_WD-WCC7K2CVN674 size: 3907018532

 

Disk0 was parity.

thanks you so much your a life saver 

how do i stop it from over writing all the data on the drives 

New config won't delete any data drive content, it will by default re-sync parity, if parity is still valid you can check that box before array start, still a good idea to run a parity check after.