[Boot Failure: bzfirmware checksum error]

On 10/17/2022 at 11:25 PM, ChatNoir said:

 

You should remplace all the bz* files on your flash drives with one pulled from the release you are using. You can get the files in the zip here : https://unraid.net/download

Helped me to. But why did it happen?

[[Support] ich777 - AMD Vendor Reset, CoralTPU, hpsahba,...]

On 9/18/2022 at 3:28 PM, ericswpark said:

Finally managed to get the temperature to show up in the plugin. Turns out the "detect" button is broken and does not scan available drivers properly.

 

Following this comment: 

 

I had to create a `drivers.conf` file in `/boot/config/plugins/dynamix.system.temp` and add the following two lines:

 

it87
k10temp

 

Then once I went back to the temperature plugin settings I was able to select the CPU/MB temperature from the dropdown.

 

One thing to note – already mentioned in the linked comment but just to make sure – don't click on "Detect" or else it will wipe out your changes and you'll have to start over.

 

The commenter in the link had to do the `modprobe force_id` thing, but I didn't have to thanks to this plugin. You probably shouldn't need it if you have this it87 plugin installed.

This helped me a lot - Final result - Done - after about 4h searching Thanks again