craignan
-
Posts
19 -
Joined
-
Last visited
Content Type
Profiles
Forums
Downloads
Store
Gallery
Bug Reports
Documentation
Landing
Posts posted by craignan
-
-
I just upgraded the fans for the hard drives. Went nowhere close to the drive. If I look at the drive through terminal, I see all the content. I just finished cleaning up my Plex content and was going to backup the drive, but now it appears that I have to start all over again. Thanks.
-
Hello,
I had to shutdown my server today to replace a part and after I restarted, I found that my Unassigned device would no longer mount. I stopped the array, started it backup in maintenance mode and attempted to do a xfs_repair /dev/sdb1 and got
xfs_repair /dev/sdb1
Phase 1 - find and verify superblock...
bad primary superblock - bad magic number !!!attempting to find secondary superblock...
.found candidate secondary superblock...
unable to verify superblock, continuing...
.found candidate secondary superblock...
unable to verify superblock, continuing...and then I tried
xfs_repair -L /dev/sdb1
and got the same message. After the 'continuing', it would just show pages and pages of ...............................................................
Any ideas on how to fix this? Should the drive just be reformatted and start again?
-
Well I removed the 10G nic, on-board lan enabled in BIOS, same issue. Tried a new flash drive, installed latest build, same issue.
-
Hello,
I do have 6.8.2 installed, that was from my original install. I've replaced the network cable with a known good working cable. I've gone ahead and reinstalled unraid on the flash drive as I didn't have anything of importance before. I have the on-board nic and a 10g network card. I haven't tried the 10g connection as of yet, would take some time to finish setting things up to use it. So far I'm still not able to get it to work.
-
Hello,
After deleting the network.cfg and rebooting, the cfg file was not present. I created a file, added the information above (changing what had to be updated) and now I get:
This site can’t be reached
192.168.1.5 took too long to respond.
-
Hello,
I just tried that a I have the same issue, IP not set.
-
Hello,
For some reason, my computer is not obtaining an IP address from the network when I boot up Unraid. The system worked a while back, but has been turned off for several months. When I started Unraid, I got the following message:
unRAID Server OS version: 6.8.2
IPv4 address: not set
IPv4 address: not set
Tower login:
I did change the bonding to "no" and got the same message. Attached is my log file.
Any help would be appreciated.
Bad primary superblock on Unassigned device
in General Support
Posted
Thanks Flubster, I just formatted the drive and started all over again. I'll take a look at testdisk in case it happens again.