[[Support] Linuxserver.io - Organizr]

How can I get the docker to pull V2 ?

[[Support] Ninthwalker - NowShowing]

1 minute ago, FredG89 said:

You can lock down the port to the IP addresses in tautulli.

You can!!!!! that is sweet.

 

Care to point me in the right direction to set it up...please

[[Support] Ninthwalker - NowShowing]

Is there any way to have a simple login be prompted?

 

If this is "open" I don't want the whole internet to have a list of what I have added.

 

Even if it is just a "Type the access code" or something simple.

 

Thanks....great work BTW

[[support] pducharme's Dockers support thread]

How do I setup the auto backups to go somewhere that I can pull from when I do updates?

[USB Disk testing]

I am using a USB to SATA adapter and it does pass all data, including smart report. 

[USB Disk testing]

I tried searching and I couldn't find an answer.

 

What I am looking to do is the following....and if it cannot be done, thats fine.

 

Since UNRAID does an awesome job at testing and clearing drives I am looking for a way to test drives before adding it to my array or using them for something else.

 

I was using a USB adapter to connect the disk to my server.  I know this works and I can see the drive when my system reboots.

 

So my questions:

 

1.  Use there a way to have USB devices recognized without rebooting.  Also, a clean way to disconnect when done.

2.  Once I can see the drive, is there a way to test/clear the drive without adding it to the array.  I added a disk to the array only to find it was bad and then I had to remove it, commit the new config and then run a parity check on a 8 TB drive (20+ hours)

 

I am running 6.4.1

 

Thanks, any advice would be great.