I am trying to use my unraid setup after a rebuild to host PFSense and for some reason I can only get one port to pass through. I could get into some vlan trickery, but that is hardly ideal since I am trying to move to a 10 gbps network with my new 1gbps internet connection.
I have been able to isolate my NICs to seperate IOMMU groups again:
IOMMU group 19:[1022:43b4] 02:04.0 PCI bridge: Advanced Micro Devices, Inc. [AMD] 300 Series Chipset PCIe Port (rev 02)
[8086:1539] 04:00.0 Ethernet controller: Intel Corporation I211 Gigabit Network Connection (rev 03)
IOMMU group 21:[1022:43b4] 02:06.0 PCI bridge: Advanced Micro Devices, Inc. [AMD] 300 Series Chipset PCIe Port (rev 02)
[8086:1539] 06:00.0 Ethernet controller: Intel Corporation I211 Gigabit Network Connection (rev 03)
and was able to accomplish this through the following syslinux modification:
I then passed through both Intel i211 Gigabit NICs to my PFSense VM, however only one igb0 is being detected now when I used to be able to see two nics.
***GUIDE*** Passing Through Network Controllers to unRAID 6 Virtual Machines
in VMs
Posted
I am trying to use my unraid setup after a rebuild to host PFSense and for some reason I can only get one port to pass through. I could get into some vlan trickery, but that is hardly ideal since I am trying to move to a 10 gbps network with my new 1gbps internet connection.
I have been able to isolate my NICs to seperate IOMMU groups again:
and was able to accomplish this through the following syslinux modification:
I then passed through both Intel i211 Gigabit NICs to my PFSense VM, however only one igb0 is being detected now when I used to be able to see two nics.
Here is the generated XML:
Any assistance in helping me get my network back up would be appreciated.