vokalemilch

Oh, I didnt know that. Thanks for pointing it out. I will give it a try.

Hi, I am having issues with my server. I am getting parity check errors every time a parity check is performed. Can anyone help me figure out what is going on? Diagnostics attached. Thanks harvardpaleomag-diagnostics-20201123-1127.zip

Hey, I am hoping to get some answers here, I recently got the HP NC523SFP and installed it into my server. The first thing I tested is an iperf run but the network crashed (see screenshot) and the server was unresponsive. I have tried restarting, resetting the network config, using different cables and ports on my switch (MikroTik) but nothing works. I realized that it 'firmware hang detected' pops up in the log. Is there something wrong with the card? Do I need to return it? I attached the diagnstics. I really appreciate any help. marvin-diagnostics-20200511-2306.zip

Hey, yeah. I tried most of them but for some reason none of the tips actually helped. I wished I could use NFS for timemachine backups. Well thanks for the help.

Hey, so I have been testing a few things. 1st Windows has a transfer rate > 60MB/s, which is awesome. Only MacOS has the terribly slow transfer rates. I tested two machines and both show the same thing. On the other hand iperf shows near GBit speeds. When I mount the Share using NFS my write speeds go way up > 60MB/s sometimes 100MB/s for short periods of time. So my take away is that the samba implementation on MacOS is terrible. Any ideas how to fix this? I cant be the only one experiencing this, right?

Hey, thanks for the reply. Yes my cache drive is not the fastest. If I disable cache the speeds are even slower (8MB/s). I should have mentioned that after reading through the forum, I already activated Turbo Mode. Any other suggestions?

Hi all, I am new to Unraid. I wanted to have a good local backup solution so I thought Unraid would be great. I have a HPe Microserver Gen 10 (I know not the best but thats what I have) with a 12 TB parity and 12 TB storage disk. I also have a 120 GB cache SSD. The server is connected to Gbit LAN and I get good GBit speeds with iperf3. However, when I am trying to copy my old backups onto the share, I have speeds that start at 20 MB/s and decay to about 8 MB/s. I am a little surprised by that. Do I have unrealistic expectations? Or is there something wrong with my setup? Attached: Diagnostics and a timeline of my latest copy session. I hope you may be able to help. tower-diagnostics-20200314-2226.zip