ninik

So I have just reset the bios on the small hardware with Ryzen 1gen. I have disabled the Cstate and enabled SVM. I have also set the current to Typical instead of Auto. Everything else is set to default/auto. No overclocking no profiles enabled. Any other suggestion to disable enable ? Motherboard series Gigabyte Technology Co., Ltd. B450M DS3H-CF CPU AMD Ryzen 3 1200

I will try resetting the bios to defaults( Pretty sure I already did that but just in case and let it run afterwards)

Also another question. Could the USB stick cause the freezing ? How does UNRAID work once loaded into memory ? Also should I try installing Ubuntu some other flavor of Linux and see if it crashes there ?

Thanks. So I have booted into safe mode and started the array. the server has frozen again after couple of hours. On the hardware side I have swapped Motherboard CPU Memory (Multiple SWAPs until I got a set that I can have 4 hours of memtest without errors) What would you suggest I swap next The NVME drive for the cache or the PSU ? ( I will assume the hard drives for the array wont cause the server to completely freeze

Is safe mode the same as just manually stopping docker, VMs etc ?

So I did 4 hours running the memtest no errors multiple passes. The server froze in 20 hours after that. This is the syslog at time of freezing syslog-previous(1)

Yes after googling around the last error turned out to be connected most of the time with the memory. I have done one and it failed. I removed 2 sticks of the memory and now with the other 2 I have a pass. I have run for 30 minutes without an error and with a pass. Do you have any recommendations for how long should I run it before I try to boot up the server again ? Thank you

syslog from last crash sys.log

Ok so I will wait until the next freeze and than grab all syslog's from the USB before booting again. Thanks

that is with mirrored to flash syslog-previous

Hello everyone, I have a trouble that my server is freezing after 12 to 36 hours usually. The only way to recover the server is to hold the shutdown button and start it again. Any suggestion is appreciated . PS : I have attached the syslog and diagnostic files I have also read many of the post and tryed adjusting diffrent settings such as the docker network to ipvlan etc. nasty-diagnostics-20240118-2106.zip syslog