Kreek123

Not sure if this is the right place for this request, but here goes. I use a Pihole-Unbound docker on my network, and every time I upgrade the docker container, I forget to change the DNS settings. I was wondering if there was any way to add the settings to the template so that I don't have to remember to go in after the fact and update the settings. The settings I'm wanting to add to the template are Settings>DNS>Upstream DNS Servers>Custom 1 (IPv4)>127.0.0.1#5335 - and Settings>DNS>Interface Settings> Permit all origins. Any help would be appreciated! Thanks!

Nevermind. I fixed it. I deleted the existing VM, and added a new VM using the previous VM's vdisk, and everything is working again. My Unraid server is now a bonafide BEAST! Thank you again for the help!!

Ok, so I made some major progress, but now I have a new issue. Unraid is now up and running with the new SAS controller, all 8 drives are recognized and plex is working again. The Nvidia GPU is installed and working providing hardware transcoding for Plex. However, I have a new problem. The one VM on this server now will not start. It just pops up with the error: Execution Error Device 0000:22:00.0 not found: could not access /sys/bus/pci/devices/0000:22:00.0/config: No such file or directory I'm guessing adding the new GPU has changed things around, but now I'm not sure how to resolve this. Any ideas?

So I was able to perform the crossflash of the card with no problems! Thank you for that info. But this line, I'm not really sure about. Could you elaborate as to what this means? I have not tried booting with the new SAS card installed since I flashed it, should I try that before I do anything else? And thanks again for the help. It is GREATLY appreciated.

I am at a loss and could really use some help. I have an Unraid server that I use for Plex. I want to add an Nvidia Quadro P2200 for hardware transcoding and I am having no luck. When I add the P2200, Unraid boots and sees the P2200, but no longer sees my SAS controller or any drives. If I remove the P2200, Unraid will then see the SAS controller and boot fine. I did some research and I think that the issue might be that my SAS controller is PCIe 2.0. So, I purchased a new SAS controller that is a PCIe 3.0, but this one doesn't work at all. Unraid boots with this controller installed (P2200 is not installed) but it will not see any drives. So now I'm back with my original SAS controller installed and Unraid is working with all my drives showing, but I'm sitting here with a $500 video card and a $200 SAS controller on my desk that don't make very good paper-weights. Any help or direction would be greatly appreciated! Specs: Motherboard: ASRockRack X470D4U2-2T Working SAS controller: LSI SAS9211-8I 8PORT Int 6GB Sata+SAS Pcie 2.0 New, non-working SAS controller: LSI Logic MegaRAID SAS 9341-8i SGL LSI00407 Nvidia GPU: PNY NVIDIA Quadro P2200 Kirk Jones