cornflake56

Members
  • Content Count

    7
  • Joined

  • Last visited

Community Reputation

1 Neutral

About cornflake56

  • Rank
    Newbie
  1. After I fixed the SATA cable issue, I ran the xfs_repair -v /dev/md1 again, no disk errors The xfs_repair operation ran successfully and repaired the disk. I took the array out of maintenance mode and started up the Array normally, the Array is back working now.
  2. It was the 3.3v sata issue, when I connected it to my icy dock which is powered by 2x Molex power the drive showed up in unraid
  3. I recently had a SATA cable connection issue, then a PSU failure now that's all fixed. I have tested disk 3 in an external HDD dock and it shows up in linux. When I connect disk 2's cable to disk 3 cable, disk 2 shows up when I connect disk 3's cable to disk 2 cable, disk 3 is still missing. I have run exhaustive tests on cables and sata ports all drives (Except disk 3) attach to all ports using all cables. Disk 3 shows as missing, I am unsure of what to do. tower-diagnostics-20201030-1607.zip
  4. I had to move my Array of 1 parity 4 disks to new motherboard after motherboard failure. New Motherboard only has 4 SATA ports and 1 NVMe port, I had to leave out disk4 out of the new array so I copied all disk 4 data to disk 3 using krusader On the new motherboard the cache drive is a 1 drive 256GB NVMe, I will be getting a 8-port PCI-e SATA card soon to give me more ports for HDD's and SATA Cache drives. When I try mount the array disk1 shows up with unreadable file system error and when I run xfs_repair -v /dev/md1 I get the following Phase 1
  5. Scrap that I'm going with a dedicated PC and i will use the threadripper for the unraid server,
  6. I have used the manual Linux method to create a VM of Linux Mint but after clicking launch VM screen goes blank. Below are some notes regarding Linux Mint 19.3 Cinnamon passed through Quadro K2200 to VM Choose audio from motherbaord VT'd and immou enabled Ryzen Threadripper 1900x Asrock X399 Tiachi 16GB DDR4 3200MHz passed through usb controller choose seaBios instead of other option Any help would be good