theWhitewizard

Thanks. Docker worked. But what was strange is all apps which i had on custom network were now showing network none. Had to manually change it to work. But still cannot access Truenas VM via openvpn whilst can access all other lan clients via openvpn running on pfsense. Can connect through local network to the Truenas VM. Dont know what the issue is here was working before enabling bonding on mellanox cx-3 which is a peer to peer connection between pc and unraid server.

Now I have the docket service by no apps running Sent from my iPhone using Tapatalk

Will all my previous apps and settings remain as is or will I have to do a Fresh install. Thanks for help…

I am getting the following message for my docker service. I had added a Mellanox CX-3 card which was working fine. However, when i enabled bonding and added to my truenas vm this issue started. Also connecting to openvpn to pfsense am unable to connect to Truenas VM even though i can connect locally. I have attached my diagnostics zip file. Thnx optimus-diagnostics-20220113-1352.zip

I had installed Dynamix Autofan however it cannot see any fans. I had installed Dynamix System Temp, it recognizes the following tcl, tccd1, tcdie. Dont know which is which. I am guessing Tcl is for processer. When i go to Dynamix Autofan it does not recognize anything. My motherboard is Asus B550f with Ryzen 3600. Please help..

Any suggestions please...

I have tried to search for encoding and streaming OBS to twitch stream through a docker container. I have seen a couple of spxlabs tutorials but unable to find the docker app for those. Any suggestions.

Replaced my Corsair 64gb vengence pro rgb 3200mhz with G Skill Trident Z RGB 64gb 3200mhz. It has been almost 15 hours with 2 passes and 3rd pass is half way with no errors. Shall I keep this running or this is enough. Shall i be running the test on multi core as the current test is on single SMP disabled. Thanks.

this is what I got. Is the ram faulty. EDIT: @JorgeB Thanks for all the help I think Ram is faulty as you advised earlier. Shall I go ahead and get these replaced. Thanks once again.

I installed a graphics card. Shall I run MemTest on SMP mode or standard?

I am running headless without GPU. Is there any way to do a memtest without a GPU.

Deleted both the files with errors. UUID: 2a43cc17-5aa1-4db1-b765-12a1d4eda47d Scrub started: Tue Dec 15 18:59:34 2020 Status: finished Duration: 0:00:45 Total to scrub: 22.81GiB Rate: 519.06MiB/s Error summary: no errors found

Now ran it with correct the errors checked. UUID: 2a43cc17-5aa1-4db1-b765-12a1d4eda47d Scrub started: Tue Dec 15 18:53:06 2020 Status: finished Duration: 0:01:53 Total to scrub: 56.91GiB Rate: 515.73MiB/s Error summary: csum=2 Corrected: 0 Uncorrectable: 2 Unverified: 0

Ran the Scrub Got the following. UUID: 2a43cc17-5aa1-4db1-b765-12a1d4eda47d Scrub started: Tue Dec 15 18:51:05 2020 Status: finished Duration: 0:01:53 Total to scrub: 56.91GiB Rate: 515.73MiB/s Error summary: csum=2 Corrected: 0 Uncorrectable: 0 Unverified: 0

I can also see there are only two files 36 gb on the cache for a share where cache is set to Yes rather than preferred which should technically move these two files to Array.