[Container for No-IP dynamic DNS updates]

where are the instructions for this?  i cant seem to find them.  thanks

[Dual Gig Ethernet Setup]

16 minutes ago, trurl said:

In the eth0 settings, enable bonding and select a bonding mode

 

This is what is showing up.  I cannot change them, they're grayed out.

 

Enable bonding: Yes

Bonding mode: active-backup (1)

Bonding members of bond0: eth0, eth1

Enable bridging: Yes

 

Interface eth1

Interface description: not configured

Enable bonding: No

Enable bridging: No

[Dual Gig Ethernet Setup]

Howdy y'all, newb here.  I am building a NAS with unraid (so far so good) and have (2) GIG Ethernet cards on my motherboard.  I have them both plugged into a switch, but only one seems to be enabled.  It says Interface eth0 is pulling an IP from router but Interface eth1 one says "not configured" and at the bottom there is a button that says "PORT DOWN".  I would ideally like to bond them in order to use 2 GIG on the NAS.  How would I go about doing this?  I have looked for documentation, but cannot find it.  Thanks so much.