rmoran

Members
 View Profile  See their activity

  • Posts

    3

  • Joined

  • Last visited

rmoran's Achievements

Noob

Noob (1/14)

0

Reputation

  1. rmoran
    where are the instructions for this? i cant seem to find them. thanks
  2. rmoran
    This is what is showing up. I cannot change them, they're grayed out. Enable bonding: Yes Bonding mode: active-backup (1) Bonding members of bond0: eth0, eth1 Enable bridging: Yes Interface eth1 Interface description: not configured Enable bonding: No Enable bridging: No
  3. rmoran started following Dual Gig Ethernet Setup
  4. rmoran
    Howdy y'all, newb here. I am building a NAS with unraid (so far so good) and have (2) GIG Ethernet cards on my motherboard. I have them both plugged into a switch, but only one seems to be enabled. It says Interface eth0 is pulling an IP from router but Interface eth1 one says "not configured" and at the bottom there is a button that says "PORT DOWN". I would ideally like to bond them in order to use 2 GIG on the NAS. How would I go about doing this? I have looked for documentation, but cannot find it. Thanks so much.