TechTitus

I tried that as well when I posted the other diagnostic. I ordered a replacement NVMe to PCIe adaptor but it looks like I don't need it. I switched PCIe slots and the server is working now. I've had an issue with another PCIe slot before so it might be time to upgrade the system. Thanks for the help.

New diagnostics. homenas01-diagnostics-20240116-1632.zip

Tried it, rebooted, and still have the same issue.

Sorry it took so long to respond. The server has been giving me hell. homenas01-diagnostics-20240116-0923.zip

Welp, the server ran for about 12 hours and went unresponsive again.

I'm back up and running, mostly. I booted into safe mode with GUI (without plugins) and everything is working. I wonder if one of the plugins or Community App got corrupted.

I don't but I don't have any parity disks.

I think I have a backup in the cloud. FFFFFFFFF! It says that the cloud backup is disabled.

Yep, that's correct.

Hi All, I've been experiencing a weird issue that has seemed to spiral out of control. It started by booting UnRaid and my Log folder would be 100% full. So I manually set the log file size through command line which works but doesn't persist reboots. Now, my server won't load the Web GUI, or let me run diagnostics through CLI and now does not allow me to connect through SSH at all. Has anyone seen this behavior?

I wish I did. I had been up for 23 hours and was just trying to get it working.

I must be doing something wrong. I setup the network.crg file but I still cannot reach the server. I logged into the server locally and the browser webGUI does not load. Says that the connection to localhost was unable to connect.

Ah ok. I'll give it a try.

Thank you. Hopefully one or two more people will respond before I try this. I don't remember having a bridge but the nic is eth0.

Hello fellow unraiders. I've been up on very little sleep trying to fix my network and did something stupid. I deleted my network.config file and need someone to post the settings for network.conf with a static IP so I can recreate the file. I understand the file gets created when missing for DHCP but I unfortunately don't have a physical router. I'm using opnsense in a VM on unRAID so the server won't be able to pull an address on boot. I was trying to move the server over to a different vlan but I apparently did something wrong which sent me down this hole. This after spending hours trying to figure out why the DHCP server wasn't working in opnsense. Thank you to everyone in advance.