[[Plugin] NUT v2 - Network UPS Tools]

I do! I will give that a try, thank you.

[[Plugin] NUT v2 - Network UPS Tools]

Is there a way to delay the startup of the plugin on server start? Currently, I'm using `custom -> apcupsd-ups` driver to pull from the apcupsd daemon, since it gives more information to me, but since they start at the same time, NUT fails to start. This means I need to go into the plugin, stop it, and manually start it again to get any data from it.

[[Plugin] NUT v2 - Network UPS Tools]

22 minutes ago, SimonF said:

If you want just to use nut you may need to change power and load settings to manual in display settings with 750va and 500w may provide loadi etc

It showed nominal, but no load information.

[[Plugin] NUT v2 - Network UPS Tools]

Apparently, the apcuspd-ups driver pulls from the apcupsd daemon. So I can run APC, and pull the data in, which is working. Works for me, for now:

[[Plugin] NUT v2 - Network UPS Tools]

1 hour ago, SimonF said:

Which nut version are you running?

 

Can you provide output of config screen

I just installed your plugin (which is how I found this thread). I'm trying to use the `apcupsd-ups` driver, but I guess it might not be installed. I can't find where the NUT version would be:

 

[[Plugin] NUT v2 - Network UPS Tools]

On 4/6/2023 at 5:08 PM, FUser said:

 

I installed this and it's working via SNMP in Standalone mode. It pulls in all the typical tings, but for Nominal Power it just shows a red W and UPS load is showing a hyphen (The UPS Load % does show a number however) and the status on the bottom shows the wattage (2358w).

 

 

 

I have a similar issue. When I run apcupsd, I get all information, including load, nominal power, etc. With NUT, I get a red W for nominal, and no data for load or load%. I'm trying to run NUT so I can scrape it with prometheus, since I'm already running it on an RPI hooked up to another UPS.