SH Development

Unraid version 6.12.8 Have an Unraid server set up with shares for Time Machine backups for two machines in our shop. The server has 4.19TB total storage across all it's drives. The first share is set up with the TM volume size limit set to 1TB. The machine that connects to it for backup works, but the size in TM preferences shows it has 4.19TB available to it, when it should show 1TB available. The second share is setup the same, but it correctly shows 1TB available, but the backups always error out. Not sure how to proceed. Thinking I should try to delete the shares, and start over, but I can't see where to delete a share.

Unraid crashed last month and I have been unable to get it running again. USB creator for Mac now no longer runs on the laptop I was using so have had to move creation to a different machine. I do have a config backup, but I am unable to get a working USB again after multiple tries. I get a "non bootable disk error" every time.

This should not apply to paid licensees.

I should also note that it no longer comes up asking me to boot with UnRaid or UnRaid GUI, which it used to do. GRUB corrupted somehow?

I did NOT change anything. In fact, I had rebooted about 4 times before with no problems. This time, flashing cursor. I really hate inconsistent behavior like this. I checked the "EFI" folder on the flash disk. It is in fact named only "EFI".

Got everything installed and setup. Some minor things not showing up right, so I rebooted the machine. Fresh install , now just sitting at a flashing cursor, won't boot. This is not starting at all well. I have a paid license. Not impressed. Not to mention the captcha just to post this message is OUT OF CONTROL. Sheesh people. The Unraid system looks so good, then to be bogged down with Captcha, then not booting. Not a good start.

Unraid 6 I didn't see a similar case in the documentation, and I do NOT want to damage the contents of the array, so I am asking to be sure...yes, I have backups, but I'd rather not have to go through that. I am migrating from OMV with twelve 3TB hard drives in a Raid 6 configuration. I have successfully booted with the USB of Unraid and can see all of the drives as unassigned. I am unaware of any that are designated as parity drives. My question is simply this...what is the next step? Will Unraid look at the existing array and just figure it out, or do I need to do something special? Sorry for being such a newbie at this...