Hey everyone,
I am having several issues with my array. I had a drive fail on me and I got my replacement drive in. The replacement drive is bigger than the original drive and the same size as my parity drives. However I am unable to stop the array by using the array stop button in the webui.
I try to go to the settings and change the settings for the Array Auto start and I do not have any luck their either. It acts as though the button is there but not linked to any scripts or use, just a button to click on.
I had to go into my config file and manually change Auto Start to no, save the file and restart Unraid in order for the server to boot without starting the Array.
I can then add the drive to the array and click start, but then Unraid says Array Starting - Mounting Disks but it doesn't progress past that point and the entire array is not usable.
I tried using maintenance mode and was able to start the array and do a manual sync, but I should not have to put my system in maintenance mode. I would like to still be able to use my system while the array is rebuilding the replaced drive as I have been able to in the past.
System setup:
Dell Poweredge R810
CPU: 4x Intel® Xeon® CPU E7- 4870 @ 2.40GHz
Memory: 128 GiB DDR3 Multi-bit ECC
R810 is connected to a Dell Powervault MD1000
I have attached the last 4 Diagnostics for review.
Thanks Everyone
mediacenter-diagnostics-20240126-1231.zip
mediacenter-diagnostics-20240126-1245.zip
mediacenter-diagnostics-20240126-1305.zip
mediacenter-diagnostics-20240126-1335.zip