Rastarize

So can I simply run those commands in a terminal window and it will install Handbrake and all required dependencies?

Is there a plugin for Handbrake? How relevant are the install instructions contained within this thread?

i assume the system crashed so you had to restart. the drive wont be listed in the webgui anyways since it is not part of the array. you should be able to see it in Joe's unMenu or if you connect with telnet. if you still cannot see it there, i would guess, that the drive is either faulty or your sata cable should be resitted. to be sure, check if you can see it through the BIOS. Thanks, I actually think the disk is bad. Another question though, if I lose my telnet session during preclear for whatever reason, is there a way for me to log in to check on the status of a preclear that was already initiated?

If the system crashed during a drive preclear, does that drive no longer show up when listing drives?

I'm a total newbie here and I just precleared a 2TB WDEADS Green Drive. These are the results I got following the preclear, any insight? It looks as though I may be missing some info? I dunno what this means, it's all Swahili to me! S.M.A.R.T. error count differences detected after pre-clear note, some 'raw' values may change, but not be an indication of a problem 54c54 < 1 Raw_Read_Error_Rate 0x002f 100 253 051 Pre-fail Always - 0 --- > 1 Raw_Read_Error_Rate 0x002f 200 200 051 Pre-fail Always - 0 63c63 < 193 Load_Cycle_Count 0x0032 200 200 000 Old_age Always - 25 --- > 193 Load_Cycle_Count 0x0032 200 200 000 Old_age Always - 26 ============================================================================