Wooderman

Hey Jonathan I deleted the partitions, and it's still only showing the same drives available. On a side note, I have these in an external enclosure to a mini-SAS cable, so I plugged it into my proxmox server as well, and all drives showed up there no problem, so I don't believe it to be a device issue. Using this on a QNAP TL-D400S, not sure if that makes a difference here.

I'm trying to add an array of 3 8TB drives to a new installation. When I run lsblk in the terminal, they all show up as follows: loop0 7:0 0 65.8M 1 loop /lib loop1 7:1 0 373.6M 1 loop /usr sda 8:0 1 57.8G 0 disk └─sda1 8:1 1 57.8G 0 part /boot sdb 8:16 0 7.3T 0 disk ├─sdb1 8:17 0 16M 0 part └─sdb2 8:18 0 7.3T 0 part sdc 8:32 0 7.3T 0 disk ├─sdc1 8:33 0 16M 0 part └─sdc2 8:34 0 7.3T 0 part sde 8:64 0 7.3T 0 disk ├─sde1 8:65 0 16M 0 part └─sde2 8:66 0 7.3T 0 part sdf 8:80 0 931.5G 0 disk ├─sdf1 8:81 0 16M 0 part └─sdf2 8:82 0 931.5G 0 part nvme1n1 259:0 0 476.9G 0 disk └─nvme1n1p1 259:1 0 476.9G 0 part nvme0n1 259:2 0 476.9G 0 disk └─nvme0n1p1 259:3 0 476.9G 0 part But when I go into the array setup GUI, it only shows sdf, sde and the nvme drives as available to mount. Dev 4 ST8000NM_000A-2KE101_000000123ACD-0:0 - 8 TB (sde) Dev 3 SPCC_Sol_id_State_Dis_000000123AE8-0:0 - 1 TB (sdf) Dev 2 HS-SSD-E1000_512G_30124598385 - 512 GB (nvme1n1) Dev 1 SAMSUNG_MZVL4512HBLU-00BH1_S6B5NF2W935113 - 512 GB (nvme0n1) I've tried mounting in the terminal line based on the UUID of the disks, but still won't populate in the GUI so I can start an array. Any thoughts on how I can get these mounted? These were used on a previous TrueNAS install and passed all SMART tests on there before setting up this build. I don't have any data I need to keep, so formatting them as needed is fine. Thanks!