SithRonin

If the same is detected, does it means my card is a defective one or I'm missing something ?

I saw this card in other forum but the reseller do not mention if you bifurcation enabled in the bios. In my case, that is my main problem because the bios in hpe proliant dl360p gen8 doesn't support pcie bifurcation. So i'm stuck with a over priced pcie riser card to add NVME ssd

In the diagnostic, where can I see all the installed drives (assigned \ unassigned) or at least all the drives detected by the bios

I installed 2 NVME ssd on the card and only 1 is available. 1 of these two drive is my cache drive so in theory the second ssd "should" appear as "unassigned"

Hey! here's the diagnostics. I tried to take a look at it but it's the first time and I was a bit lost darklord-diagnostics-20230426-2129.zip

witch part of the diagnostic you need?

Thanks for this answer ! I bought and install the first adapter card. unfortunately, it doesn't seems to work. I have 2 nvme ssd installed and only one shows up in unraid

Unfortunately, the bios in the proliant dl360p gen8 doesn't support bifurcation

Thanks for the reply ! the hardware of my UNraid server is a HPE proliant dl360p gen8 (Intel Xeon). I saw a video from a guy who installed the IO Crest adapter (4x nvme) on the same server and it was working flawlessly. So I was wondering if I could encounter any problem with UNraid.

hello, I'm new with UNRAID (and linux) and I would like to know If I could use these kind of adpater to add some nvme drive → https://a.co/d/geBwOPd → https://a.co/d/h37oStN

Hello ! I' m a new user of UNraid (for about a week) and the DOCKER environnement is a new thing as well. My UNRAID server hardware: hpe proliant dl360p gen8 2x Intel® Xeon® CPU E5-2680 @ 2.70GHz 64g ecc ram raid controller p420i (in HBA mode) HPE Ethernet 1Gb 4-port 331FLR adapter I managed to install all the dockers I need (PLEX,sonarr,radarr,etc) but now I want to go a step further. I would like dedicate eth port for my dockers. ex: 1 port for the server itself, 1 port for plex (possibly 2 port with aggregation) and 1 port for my dowloads dockers. I know I must connect those port on different vlans or network and my network setup is properly configured to support this. So my question is how do I configure the network settings of unraid vs the network settings for each dockers. I played around with the bond,bridge,host configuration but I don't know to proceed with dockers thank !

hello, I 'm a new user of unraid (and dockers too). I have decide to give unraid a shot with my server - hpe proliant dl360p - which has a embedded 4 nic adapters. (+1 for iLO). I would like to dedicate nics for a pricise docker. for exemple 2 nics for plex (in a load balancing mode), 1 for downloaders dockers (sonarr,radarr,etc). the plex docker and the downloaders docker would preferably be on segregated networks (different network/subnet). I have read some howto's but i don't seems to properly understand how does the networking works with unraid / docker. Thanks !