renzema

Thank you for the assistance. After rebuilding the usb, slowly added back configs until I found the root cause. Something in the docker configs was failing out. Was able to get the array, plugins, VMs and server configs though and I will take that as a win. Just glad to have all of the folder permissions and SMB users/pass back on it. Would love to know what in there causes the issue, being it works perfect on my old build and only fails on the new build.

Just for clarification. I am going to need to move storage, pool, cache, key file, and super.dat. That will give me all of my data and arrary but nothing more correct? I am fine rebuilding the docker containers and plug-ins, if I have to, however want to avoid needing to re-add all the data.

Today I moved my array, cache and usb over to the new build, listed below. I ran into a strange issue that I haven't been able to find any information on, and I have been digging through prior posts and other sites. MOBO: ASRock z790 Lightning WiFi CPU: intel i7-14700k RAM: Corsair Vengeance DDR5 2x32gb Issue: Unraid will boot into any other option but "Unraid OS". Right now I have it running as "Unraid Webgui", which has it functional with no errors showing the logs. All apps, plugins and vms start with no errors. If I try to boot to Unraid OS the system loads all the way up until it trys to launch the OS, no errors shown, and locks the system up. The last entry is loading mcelog. The only way to resolve is a hard restart. A clean install on the usb of unraid does boot without issue. Steps already taken: 1) updated the bios for the 14th gen chip. 2) Went through the bios to verify virtual infrasture and vt-d is enabled. 3) fast boot is disabled(no change) 4) secure boot is disable(no change) 5) rebuilt the usb using unraid creator and manual creation. Then moved the config over. 6) Replaced the prior usb with a new one. 7) Removed all of the plug-ins and re-installed once getting the system up under "Unraid WebGui" Moved everything back to the old build and it boots fine again. Everything points to an issue with the config somewhere, but I am not sure where to look. I don't want to wipe the data from the array and start over as I have a lot of unique configs built. Any advice is appreciated and thank you.

I have a windows 10 vm that boots up no errors and gets its DHCP reservation. I can RDP into it, but after a random amount of time, no more than 1 hour, it's connection fails. I can still see its connected to the router but it no longer responses to pings. I can reboot the VM and it still will not come back up. The only way to resolve it is to either reboot the whole unraid server or shut the vm down and boot it up much later. I am at my wits end trouble shooting this thing. I have rebuilt the VM, verified all network drivers are updated, shutdown docker and all other resources, and tried muliple different network adapter types. Nothing changes the failure so far. Below is the log from the VM and I don't see anything that is standing out and showing a failure. I am not sure what diagnostic file to link up here for better trouble shooting. Thank you for your help.