Jozzie88

I did a test, put everything back onto the ONT and I can see it from my devices on the network now. But I'm back at square one for the port issues. Apparently Telus keeps ports locked for residential. I could try the above, Ugh, if it were me, I'd get rid of all the Telus stuff. But because they use wifi mesh system for their tv boxes you have to have them.

The wifi on the old D-Link is brutal 150-300mpbs sometimes. Also the D-Link router is down in the basement But the wifi 6 via telus mesh system I'll be in the 880-920 range. Wired I'm 1 -1.1gbps. I'm going to try swapping the server to the ont and see. This kinda sucks.

Only reason i am using the Telus Wifi is sue to WIFI 6. My d link is older. Other option i switch the Server back to the ONT and try and see if i can get Telus to open the ports for me.

Hi all, The issue im having now that ive gone Bridge mode is not being able to see my server on the same network over wifi. i suspect its due to the devices being connected to the other router vs the one that the actual server is connected to. Setup Telus ONT Modem (wifi Enabled) (Bridged Mode) ------ Dlink Router (wifi Disabled) ( Server, Main computer are connected to this) i have 2 computers on WIFI that cant see the or pick up the modem including my phone. Any ideas? When i was all in on the ONT the whole network could connect to it. Reason for using the Dlink Router is due to the ONT being locked down, no ports able to open or change any back end settings. Thanks