MrWGT

I'm running Unraid 7.3.0 beta2 on my server and got my intel e610-xt2 yesterday. Replaced my Gigabyte 10GBit/s networkcard (with AQC113 chip) because aqc113 card looses network after 1-3weeks uptime. After powering up no network due to cable connected to lower rj45 port (which is eth1). Connected to upper rj45, rebooted and all is fine. Server reaches now C10 instead of C8 and power went down ~2.5W. Maybe the used power increases after a few days - at least i've seen this qith aqc113 where power is 1-2W less after a reboot compared to one week later. System is a gigabyte z690 ud ddr4 board, 2 NVMe installed, 64GB DDR4, 6 hdds in standby. Otherwise only usb stick connected and 3 dockers are running but normaly idle.

Login from iPad works Login over LTE+VPN with iPhone works Login over local WIFI and iphone throws "to many failed logins". Can't understand. Is there a ip address blocking running? Because iPhone always gets same ip in WIFI but different one over LTE+VPN.

Just now my unraid server started to complain about "to many failed logins" when opening start page from iphone. If i try it from pc the same login/pw works without a problem. sshing into from iphone works also ok with login/pw. Just not from Safari, Chrome, Edge... Is this problem known and how to solve it?

I bought a GIGABYTE Z690 UD DDR4, installed the following parts: i5-13500 96 GB RAM 1.2V 3200Mz 2x 18TB MG09ACA 1x 14TB WD HD out of MyBook 1x 4GB Crucial M2 SSD 1x 2GB AData SSD GIGABYTE VISION 10G LAN with AQC113 Be Quiet Pure Power 11 FM L11-FM-550W 2x 120mm chassis fans Setting a lot of bios options from auto to normal, enabling c-statesand so on, some undervolting, disabling Turbo and powertop --auto i could reach C10 for Pkg(HW) with ~37-39W running a single Lubuntu VM. Are there other ways/tipps/tricks to squeeze out some more watts? Gerd