jun12047

Bug反馈 （每个版本都有这个问题，最新的6.12.8也是这样） 1、Docker 网页上安装软件拉取镜像时，Webui就会卡死了。Docker镜像下载多长时间，就能卡死多长时间，求解决办法。 卡死就只能SSH中，输入命令让Docker 停止后在重启才能再次恢复unraid webui网页管理网站。 /etc/rc.d/rc.docker restart /stop /start 建议优化： 1、 网关建议可以设置2个，一个指向可机场的旁路由，在旁路由不能用时，自动指向主网关可上网。 2、假如是unraid中启动的带有可机场的旁路由，设置网络时，必须要关闭阵列，没有旁路由就不能机场，故假如新安装了系统时，国内，一不能安装应用中心，二没有中文字体，三也没法安装插件，简直是无限死循环。 3、 建议Unraid自带中文，没有机场的话，应用中心不能安装，中文字体也不能安装。 4、 Docker的镜像源也只能通过命令修改，不能通过ui设置，国内也完全不好用，建议针对国内用户，添加一些国内优化的选项，以供切换相应可用的源。 以下AI自动翻译： The following is automatically translated by AI： Bug feedback: 1. When installing software on the Docker web page and pulling the image, the Webui will get stuck. The Docker image will be stuck for as long as it takes to download, and we are looking for a solution. Suggested optimizations: 1. It is recommended to set up two gateways, one pointing to the side router of the airport, and when the side router is not available, it will automatically point to the main gateway for internet access. 2. If it is a side router with an airport started in unraid, when setting up the network, the array must be turned off. Without a side router, there is no airport. Therefore, when a new system is installed, in China, one cannot install the application center, two there is no Chinese font, and three there is no way to install plugins, which is simply an infinite dead loop. 3. It is recommended that Unraid comes with Chinese. Without an airport, the application center cannot be installed, and Chinese fonts cannot be installed either. 4. The Docker image source can only be modified through commands, and it cannot be set through the ui. It is not fully usable in China. It is recommended to add some domestic-optimized options for domestic users to switch to the corresponding available sources.