Draxis

Thank you! The drive was reformatted correctly this time. Wish I knew what caused it t fail the first time, but hey, if it's working it's working!

As a quick update since there was some back and forth on the Discord: Tried running xfs_repair -n /dev/md1p1 It produces the same result of the XFS repair tool from the WebGUI Phase 1 - find and verify superblock... bad primary superblock - bad magic number !!! attempting to find secondary superblock... warning: device is not properly aligned /dev/md1p1 ..Sorry, could not find valid secondary superblock Exiting now. Then tried "wipefs /dev/md1p1" but it just produces a blank line

Apologies, I'm not sure how to run those commands in the WebUI. For right now ran the command in the CLI and got thebrunhild-diagnostics-20260529-2324.zip following: Disk /dev/sdb: 10.91 TiB, 12000138625024 bytes, 23437770752 sectors Disk model: ST12000NT001-3MD Units: sectors of 1 * 512 = 512 bytes Sector size (logical/physical): 512 bytes / 4096 bytes I/O size (minimum/optimal): 4096 bytes / 4096 bytes Disklabel type: gpt Disk identifier: 3D1C1F05-062A-42FA-8C46-B03907040601 Device Start End Sectors Size Type /dev/sdb1 34 32767 32734 16M Microsoft reserved Partition 1 does not start on physical sector boundary. Heres the new diagnostic data. Thank you again for the help.

Hello, first time poster. I originally asked on the Discord server but was directed to post here with the diagnostics info. Not sure how much info I should include in this body so I'll take it from the top. I have a brand new Unraid server, so there is no data on any of the disks. Both drives are brand new, tested perfectly good in crystaldisk before I put them in the server, and did not have any errors when I tested them with the SMART extended self test tool. As troubleshooting 101 I replaced the sata cables for the hard drive and uplugged and replugged everything in just to try and rule out a hardware issue. Went to run xfs repair after putting the array in maintenance mood and only got this Phase 1 - find and verify superblock... bad primary superblock - bad magic number !!! attempting to find secondary superblock... warning: device is not properly aligned /dev/md1p1 ..Sorry, could not find valid secondary superblock Exiting now.Tried reading around for similiar issues. Went to the CLI and ran xfs_repair -L /dev/sdb Phase 1 - find and verify superblock... bad primary superblock - bad magic number !!! attempting to find secondary superblock... with it infinitely printing . after, I assume indicating its searching through the data. Anyhow it doesn't seem to work. Thank you in advance for your help. brunhild-diagnostics-20260529-2238.zip