pischke

I've installed the new release as well with no problems. I'm currently in the process of upgrading a drive from 120GB to 400GB (using the same drive that always showed as Disabled with the older releases), and it seems to be working fine (although it's currently predicting 1300+ minutes to rebuild the drive - yoiks!) -mike

Thanks for the info Joe. I'm not desperate for the extra space right now, so I might just put the 120GB drive back in until this issue is sorted out (fingers crossed). If I put the 120GB drive back in and "reset array configuration", I should be back where I started, right? It shouldn't erase any of my data drives, including the 120GB? I really don't want to have to re-rip 2.5TB of DVDs.... -mike

Hey all, I just ran into this problem (or something similar) using the 1.050930 software. I have a "full" server (12 disks) and was replacing a 120GB drive with a 400GB drive. The upgrade apparently failed, and my status page now shows the new 400GB drive as disabled. I tried putting the original 120GB drive back in, but I got a "drive too small" error. So, at this stage, I guess my only option is to put the 120GB drive back in and do the "reset array configuration"? This should just regenerate parity based on the current contents of the data drives, correct? TIA. -mike