[Preclear.sh results - Questions about your results? Post them here.]

I'm very new to unRaid and have just finished preclearing (using the preclear plug-in) 3 6tb WD reds. 2 came back perfect but the third came back with some Seek Error Read info which I dont understand. Should I be concerned? I have express RMA for another 2 weeks on this drive so exchanging it shouldnt be a problem as long as this problem warrants an exchange, could this just be bad cable? maybe I can re do the test using a different cable, 56 hours to preclear though...... I appreciate any help I get, Thanks.

 

Also, am I finished with the preclear process or is there another step I should do before creating the array and starting a parity sync?

 

THANKS!

 

================================================================== 1.15

=                unRAID server Pre-Clear disk /dev/sdb

=              cycle 1 of 1, partition start on sector 1

= Disk Pre-Clear-Read completed                                DONE

= Step 1 of 10 - Copying zeros to first 2048k bytes            DONE

= Step 2 of 10 - Copying zeros to remainder of disk to clear it DONE

= Step 3 of 10 - Disk is now cleared from MBR onward.          DONE

= Step 4 of 10 - Clearing MBR bytes for partition 2,3 & 4      DONE

= Step 5 of 10 - Clearing MBR code area                        DONE

= Step 6 of 10 - Setting MBR signature bytes                    DONE

= Step 7 of 10 - Setting partition 1 to precleared state        DONE

= Step 8 of 10 - Notifying kernel we changed the partitioning  DONE

= Step 9 of 10 - Creating the /dev/disk/by* entries            DONE

= Step 10 of 10 - Verifying if the MBR is cleared.              DONE

= Disk Post-Clear-Read completed                                DONE

Disk Temperature: 23C, Elapsed Time:  55:21:39

========================================================================1.15

== WDCWD60EFRX

== Disk /dev/sdb has been successfully precleared

== with a starting sector of 1

============================================================================

** Changed attributes in files: /tmp/smart_start_sdb  /tmp/smart_finish_sdb

                ATTRIBUTE  NEW_VAL OLD_VAL FAILURE_THRESHOLD STATUS      RAW_VALUE

          Seek_Error_Rate =  100    200            0        ok          0

      Temperature_Celsius =  129    126            0        ok          23

No SMART attributes are FAILING_NOW

0 sectors were pending re-allocation before the start of the preclear.

0 sectors were pending re-allocation after pre-read in cycle 1 of 1.

0 sectors were pending re-allocation after zero of disk in cycle 1 of 1.

0 sectors are pending re-allocation at the end of the preclear,

    the number of sectors pending re-allocation did not change.

0 sectors had been re-allocated before the start of the preclear.

0 sectors are re-allocated at the end of the preclear,

    the number of sectors re-allocated did not change.