iCarl

I've attached the syslog below, issues happened sometime between 10am - 10:30am on 12/24 Based on @Jryski's post, I may need to move away from bridging? I do have Ubiquiti and realtek gear, it sounds like I'm square in the middle of a few PRB's! I followed the first few recommendations here, but haven't moved all of my dockers off Bridge yet. syslog

My Unraid server has started becoming unresponsive, requiring a hard reboot to bring it back & sometimes multiple hard reboots. I initially thought it was a bad nic port on my motherboard and installed a fiber PCI card which worked fine for a day or two, but then issues persisted. Today I connected a monitor to the normally headless server and when it became unresponsive I logged in at the server where it looked normal. It then became responsive again after doing so. I've noticed other times where it'll be responsive, unresponsive for a short moment and show the array not started and the docker not running due to that, then the array starts and the docker also starts. I'm really hoping it's not a hardware issue, but would appreciate any help! I've posted diagnostics below. The last known issue happened 12/23 around 10pm-11:15pm. icarlnas-diagnostics-20231223-2311.zip

I noticed a lot of these in the logs: unraid kernel: atlantic 0000:01:00.0: PCIe Bus Error: severity=Corrected, type=Physical Layer, (Receiver ID) I followed this guide to add a config to my syslinux configuration and things seem to have improved!

unraid-diagnostics-20231220-2045.zipI seem to be having the same problem, can someone please help?

This also worked for me, thank you!

the connector on the disk itself. A heads up to others with the Fractal Node case, when sliding in the tray of HHDs be mindful of clearance with the power supply... it bent my Sata connector and snapped off one HHDs Sata pins.

Diagnostics attached, I know the drive failed because the sata port was damaged when doing maintenance on the server. Unraid-diagnostics-20220910-2227.zip

One of my data disks has recently failed, I have dual parity and would like to use of the two parity drives as the new data disk. Could I just remove the second parity drive and let unraid rebuild the failed drive on that? I'd like to make sure not to lose data so I'm asking here before doing anything.

Thanks for your help! this solved my problem.

Received this error and was hoping for some guidance on what it means. "Your server has detected hardware errors. You should install mcelog via the NerdPack plugin, post your diagnostics and ask for assistance on the unRaid forums. The output of mcelog (if installed) has been logged" logs attached, any help is appreciated! icarlnas-diagnostics-20210331-2110.zip