.Nexus

Members
 View Profile  See their activity

  • Posts

    12

  • Joined

  • Last visited

 Content Type 

Everything posted by .Nexus

  1. .Nexus
    I seemed to have missed that option, formatted it now and the drive is now available. Thanks for the help guys!
  2. .Nexus
    Ah I'm a silly goose, how would I go about removing the drive from the array then formatting it?
  3. .Nexus
    The only issue is that I've added the drive to the array. Should I remove the drive from the array so I can run that plugin?
  4. .Nexus
    No, I purchased the drive new from Amazon.
  5. .Nexus
    Hello everyone, I purchased a 4TB WD Red drive, and installed it into my server. UnRAID detects it but when I start the array it will say " Unmountable: Unsupported partition layout" on that particular drive. The other drives in the system are 2 2TB WD Red's and a 250GB Samsung Evo SSD. I'm using a Dell H200 raid card and I've attached the diagnostics of the server. pico-diagnostics-20180630-1646.zip
  6. .Nexus
    I've contacted the support team asking what card would be compatible with the server. I don't have any breakout cables so I'm going to look into buying one.
  7. .Nexus
    I contacted the support team for the company I bought the server off and it turns out that the Dell H200 isn't compatible with Chenbro systems (The system which I have). Is there any alternative card I could buy that has an IT mode?
  8. .Nexus
    Well I reflashed the card and I installed the BIOS for it. So it now displays that image. When the server is powered on the drive activity light will flash once on the hard drive bays but that is all they do.
  9. .Nexus
    When I power the server on it will say the VGA accelerator, then it will display a POST screen allowing me to access the regular BIOS, then it will boot to unraid. Before I flashed the card it did present a screen about configuration but I never did anything there and went straight for the flash. I've included the information about the card when I ran " sas2flsh.exe -c 0 -list" if it helps. I followed this guide roughly.
  10. .Nexus
    Well I'm using these cables since the previous ones where too short to reach the HBA's port. I'm not too sure on how to access the HBA's bios, is it inside the regular one?
  11. .Nexus
    Here's the diagnostics, I'm going to try get a reverse breakout cable for the SSD so it can remain in the caddy, but be plugged into the SATA ports. pico-diagnostics-20180604-1029.zip
  12. .Nexus
    Hello I've just installed unraid and just flashed the Dell H200 to IT mode. So I put an SSD and a 2TB drive in to the drive bay, and unraid doesn't seem to see them. is it possible I flashed the H200 incorrectly?