Hello,
I’ll start by saying, yes, this is going to be a time-costly lesson to me on backing up my flash configuration. That said...
While adding a new drive to my array, the flash drive failed on reboot. I have already reinstalled unRaid on a spare flash drive, booted, and replaced the key. I have also (with the wealth of knowledge available in the forum) managed to manually mount each drive and determine which drive contained what.
I thought the CA Appdata Backup / Restore was backing up the flash drive, but cannot locate any folder/file resembling the USB flash backup. I was able to find the folder where backups were occurring, and found backups of various dockers, vms, and libvrt.img (?), but no flash.
I’m assuming I’ve lost the setup and have a theory going forward on how to restore.
When I attempted to assign disks to their previous locations and started the array, everything assigned in a different order than desired. What’d I’d like to do is reset the config without losing the data currently on the drives (mostly backup data, but took a very long time to get the data there).
So put simply, how do I set a new configuration “without” losing the data? And how do I ensure the disks are put in the order I want them to be?
Thank you much in advance.
Em
p.s. Did try searching the forums, which got me as far as I could. If there IS a post that addresses my need, please kindly just post a link and I’ll read thoroughly and rebuild my array. Again, thank you. 🙂