Hello All, Hope you can help
I had a disk (disk 1) fail. I removed it and purchased a new one(WD Red WD30EFRX). Everything is running fine (in emulated mode on disk1) . When I put the new drive in, and assign it, it starts the rebuild and gets errors within seconds. I purchased another drive (same model), thinking it was a bad drive and put that one in. Same thing.
The drive goes to Disabled / Emulated. I then changed the SATA connector to a different SATA port and assigned the disk to disk1. Same thing happens. I'm kind of at a loss at what to do to get the drive back to "good"
Attached is my diagnostics report.
Thanks in Advance.
dransik-diagnostics-20190130-2131.zip