Tygger

Happy Thanksgiving and thank you for the respond. I've been delaying doing anything and reading as much as I can. I've identified my parity and cache drive. Under New Config, I selected "Preserve Current Assignments: All" and went to assign the drives. I did not select "Parity is already valid" or "Maintenance Mode." When I Start, I get a warning that says "Parity disk(s) content will be overwritten." Before I hit Proceed, can someone confirm if this is correct and/or a normal part of the process? Thanks again

Big noob here. My flash drive died and I restored it from a backup. Unfortunately, my backup is 1yr old and didn't have the latest drive assignments. I failed by not doing regular backups or labeling my drives. Lesson learned! I have 1 cache, 1 parity, and 2 storage drives. I know which one is my parity and my cache, but not sure about the 2 storage drives. From what I read, I think I need to use New Config. Could someone step me through this process so I don't mess everything up? Thanks!

The drives don't show up in BIOS. I've tried swapping the power and data from a drive that does work to no avail. Ithen removed the non-working HDDs and installed in a different machine and it did show up in BIOS. To recap, the SDD and 500gb HDD shows up, but the two 8TB HDDs don't.

Ok, I'm returning it. Just ordered EVGA SuperNOVA 650 P2, 80+ PLATINUM 650W. In the mean time, any tips on further trouble shooting? Thanks all

Thanks. Missed the point. Yes, powered the same way. Appreciate it. Will take a look. Any other suggestions? Thanks

No, not modular, but I did just order a EVGA 850BQ. Wasn't sure if they PSU I swapped in was bad... but now I think I need to cancel my order for a non-modular?

My power supply died. I swapped with a old PSU I had laying around and now I'm getting missing devices. Attached is my diagnostics. Any idea what's going on? Thank you tower-diagnostics-20220911-1931.zip