smexyrabbi

Which file was that error located in?

The issue still occurs in safe mode. Perhaps either the nic or the switch it is connected to

tower-diagnostics-20241031-2249.zip

https://docs.unraid.net/unraid-os/troubleshooting/diagnostics-information/ Will post em soon

Hi All, I just installed a 10GB NIC in my unraid box. I set eth0 to the mac address of one of its 2 ports. I can ping it on the network and use ssh fine however the webui is impossible to use. I can use the local gui when booting into it however otherwise I cannot. Is there a way I can get logs without using the ui to show yall?

Just happened again. I disabled the power c states global and set power supply control to idle always as recommended. tower-diagnostics-20230426-2311.zip the zip named (1) is off of the usb logs folder. tower-diagnostics-20230426-2311 (1).zip

Gave it a try . Will lyk if it worked or not. Not sure why suddenly it would be an issue but 🙏

Hello, I have a chenbro 8bay rackmount chassis with a zippy m3w 6950p by emacs. Recently the powersupply started beeping a lot however it never caused the server to turn off so I assumed that the dust build up was causing issues. I cleaned out the server and it was working fine until one day I couldn't access the web Gui so i hard shutdown the server and booted it back up. I checked logs but didn't see anything suspicious. Whenever i reboot it , it keeps saying unexpected shutdown and starts preforming a parity check when I start the array. The server runs for about 13 hours then just shuts off. I think the culprit is the power supply since I was leaving for work and I heard a beep and my server was no longer accessible. However here are the longs from the unexpected shutdown. I downloaded them from the USB logs folder. I would appreciate any advise or troubleshooting steps you can provide me. tower-diagnostics-20230425-2015.zip

Ok I believe I solved the issue by removing the 2 unassigned devices plugins. Its been an hour and i've had 150mb /s consistently.

as a side note i just uninstalled unassigned devices and so far my speeds are around 150mb/s

What do you think I should do?. It used to go up to 140MB/s a long time ago. I don't think it is my hba card.

latest diag at time of pic tower-diagnostics-20220726-1904.zip

i

Hello I'm a noob at looking at logs. My parity check has been pretty slow lately averaging around 50 MB\S to 90 MB\s. I turned off all docker containers to see if they affected the speed but my results were the same. Open to any suggestions :) tower-diagnostics-20220726-1839.zip