grog189

Good day, I recently setup my Unraid server without any issues and have been trying to get the Unraid Nvidia plugin to work. I've installed it twice from the community applications plugin with my Unraid being at 6.8.3 and choosing the Unraid Nvidia 6.8.3. Everything runs fine until the install finishes and it wants me to reboot, when I reboot my Unraid just gets to a certain point and hangs there. I've attached 3 videos of what happens. I'm going to try again but not use community plugin this time, just sucks because I have to set my entire Unraid server back up each time. If anyone is able to assist me that would be great. Here are my specs: Supermicro SuperServer 6047R-E1R24N 24-Bay LFF 4U Rackmount Server Processor 1: Intel Xeon E5-2630L v2 2.4GHz 6 Core 15MB Cache Processor Processor 2: Intel Xeon E5-2630L v2 2.4GHz 6 Core 15MB Cache Processor LSI SAS 9211-8i Nvidia Quadro p400 Samsung 16GB 2X 8GB PC3-10600R DDR3 1333MHz 240Pin ECC Reg RDIMM RAM Memory x4 Unraid Pro v6.8.3 Nvidia Issue Gui-1.mp4 Nvidia Issue No Gui-1(1).mp4 Nvidia Issue Safemode Gui-1.mp4

Good Evening everyone I was hoping to get some assistance as I am completely confused even though I have tried to read everything I can find to help me figure it out. I am looking at these two servers being sold by metservers for my Unraid 24 bay 4 u rackmount build. https://www.metservers.com/Supermicro-SuperServer-6047R-E1R24N-24-Bay-LFF-4U-Rackmount-Server and https://www.metservers.com/Supermicro-CSE-846-CSE-846-24-Bay-LFF-4U-Rackmount-Server Far as I can tell the cases and backplane are the same with the only major difference is one has the motherboard X9DRi-F and the other has X9DRi-LN4F+, along with one having 1200W gold power supply while the other has 920W platinum. This is where I am confused, the one that comes with the X9DRi-F also comes with the LSI 9210-8i IT mode controller, while the X9DRi-LN4F+ does not come with one. Will I be able to use the X9DRi-LN4F+ with the on board controller to manage the backplane instead of requiring the LSI 9210-8i IT mode controller? Or will I have to buy a controller? I've tried to read through the Supermicro documentation but I just do not know enough about server hardware to make a definitive decision. Also emailed metservers but they have not responded as of yet. *Thank you for taking the time to assist me!*